[. . . ] Couverture arrière Dryer Safety 2 IMPORTANT: When discarding or storing your old clothes dryer, remove the door. 3 Accessories Enhance your new washer and dryer with the following genuine Whirlpool accessories. For more information on options and ordering, call 1-800-901-2042, or visit us at: www. Ca Worksurface The worksurface bridges the washer and dryer, and provides a convenient working and storage area. [. . . ] Damp This indicator shows that the load is partially dried and items that you may wish to hang up or iron while still damp may be removed. Cool Down The dryer has finished drying with heat, and is now tumbling the load without heat to cool it down and reduce wrinkling. Done This will indicate that the selected cycle has ended and the load may be removed from the dryer. If Wrinkle Shield™ has been selected, the dryer may continue to tumble the load, even if the Done indicator is lit. Sensing The Sensing indicator will light to indicate that the moisture sensor on the dryer is operating. Static Reduce (on some models) This indicator will light when the Static Reduce function is active. Steam or Steaming (on some models) This indicator will light when the Steam function is active. Wrinkle Shield™ Option This indicator will light if the Wrinkle Shield™ option has been selected and is running. The dryer will periodically tumble the load for up to 140 minutes after the cycle has ended. Align the two hooks on the front of the drying rack with the holes in the dryer door opening and press down fully into holes. The drying rack does not move, but the drum will rotate; be sure to leave adequate clearance between items and the inside of the dryer drum. Make sure items do not hang over the edges or between drying rack grille. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Only setting. When the cycle is selected, the Estimated Time Remaining display shows the default time. You can change the actual time in the cycle by increasing or decreasing the cycle time. NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack after the cycle is finished. 12 Dryer Care CLEANING THE DRYER LOCATION Keep dryer area clear and free from items that would block the air flow for proper dryer operation. CLEANING THE LINT SCREEN Every load cleaning The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen after each load. IMPORTANT: n Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. N If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. [. . . ] Some states and provinces do not allow limitations on the duration of implied warranties of merchantability or fitness, so this limitation may not apply to you. This warranty gives you specific legal rights, and you also may have other rights that vary from state to state or province to province. DISCLAIMER OF REPRESENTATIONS OUTSIDE OF WARRANTY Whirlpool makes no representations about the quality, durability, or need for service or repair of this major appliance other than the representations contained in this Warranty. If you want a longer or more comprehensive warranty than the limited warranty that comes with this major appliance, you should ask Whirlpool or your retailer about buying an extended warranty. [. . . ]